+353-1-416-8900REST OF WORLD
+44-20-3973-8888REST OF WORLD
1-917-300-0470EAST COAST U.S
1-800-526-8630U.S. (TOLL FREE)


Electrohydraulic Fracturing of Rocks. Edition No. 1

  • ID: 5186434
  • Book
  • February 2016
  • 130 Pages
  • John Wiley and Sons Ltd

This book presents a new fracturing technique that should be considered as a potential alternative, or a companion technique, to hydraulic fracturing of tight gas reservoirs and low permeability rock masses. As opposed to hydraulic fracturing which generates a few numbers of large cracks, electro-hydraulic fracturing induces diffuse micro-cracking and fragmentation of rocks. Laboratory tests demonstrate that increases of permeability by two orders of magnitude can be reached, without major cracking in tested specimens. This book discusses the principles of this new technique, reports experiments which have been developed is order to prove the concept and finally describes the numerical model from which the potentialities of this technique in representative reservoir conditions can be assessed.

Note: Product cover images may vary from those shown

Preface vii

Introduction xi

Chapter 1 Experiments in a Representative Environment 1

1.1 Mechanical set-up 1

1.2 Pulsed arc electric generator 4

1.3 Material properties 6

1.4 Measurements of radical permeability 7

1.5 X-ray tomography 9

1.6 Results on model materials 10

1.7 Summary of the results on sandstone 17

1.8 Discussion 18

Chapter 2 Computational Modeling of the Process: Principles 21

2.1 Pressure generated by the pulsed arc electrical discharge 22

2.2 Mechanical modeling of rocks under dynamic loads 29

2.3 Coupled effects between damage and permeability 41

2.4 Summary and conclusions 44

Chapter 3 Validation of the Computational Model 47

3.1 Simulation of the experiments in uniaxial compression 47

3.2 Confined tests on hollow cylinders 52

3.3 Isotropic versus anisotropic permeability 67

3.4 Conclusions 68

Chapter 4 Computations on Representative Reservoir Geometries 71

4.1 Effect of repeated shocks 72

4.2 Simulation on a typical reservoir geometry 75

4.3 Optimization of the process 79

Concluding Remarks and Future Outlook 91

Bibliography 97

Index 103

Note: Product cover images may vary from those shown
Christian La Borderie
Thierry Reess
Wen Chen
Olivier Maurel
Franck Rey-Berbeder
Antoine de Ferron
Note: Product cover images may vary from those shown