New Trends in Observer-based Control. A Practical Guide to Process and Engineering Applications. Emerging Methodologies and Applications in Modelling, Identification and Control

Table of Contents

Part I. Power Systems 1. Active Load Reduction in Large Scale Wind Turbines using Non-linear Quadratic Disturbance Observer 2. Observer-Based Controller of Analytical Complex Systems- Application for a Large Scale Power System 3. Robust Control for Wind Turbines using Sliding Modes based Compensation 4. Meta Heuristic Optimized control strategies for Hybrid DC- AC systems 5. Distributed Nonlinear Control of Microgrids

Part II. Robotics and Mechatronics 6. Finite Time Observer Design for Nonholonomic Systems 7. Robust Observer-based Stabilization for Constrained Robots with Force and Parameter Estimation: Application to the ABB-IRB 140 Industrial Robot 8. Design of a Composite Control in Two-time Scale using Disturbance State Observer based SMC and Backstepping Control of a Two-link Flexible Manipulator 9. Robust Observer-based Control of the Inverted Pendulum System Subject to Communication Delays

Part III. Flight and Automotive dynamics 10. A class of Nonlinear Unknown Input Observers under L2-gain performance for Fault Diagnosis: Application to the Mars Sample Return mission 11. A Class of Reduced-order Multiple Observers with Applications to Aircraft Landing 12. Disturbance Observer-Based Control of Spacecraft Attitude Dynamics Subject to Perturbations and Underactuation 13. Actuator or/and Sensor Fault Detection Based on LPV Unknown Input Observer Applied to Lateral Vehicle Dynamics

Part IV. Bio-Industry 14. Observer-Based Trajectory Tracking for an Anaerobic Digestion Process by Using New LMI Method

Authors

Olfa Boubaker Professor, National Institute of Applied Science and Technology (INSAT), University of Carthage, Tunis, Tunisia. Olfa Boubaker received her PhD degree in Electrical Engineering from the National Engineering School of Tunis (ENIT) and Habilitation Universitaire degree in Control Engineering from the National Engineering School of Sfax (ENIS), in Tunisia. She is currently a full professor at the National Institute of Applied Science and Technology (INSAT) of University of Carthage where she is actively engaged in teaching and research in control theory, nonlinear systems, and robotics. Professor Boubaker has participated in several research projects in sustainable development areas including the fields of medical robotics, green energy, water preservation, and environment protection. She has supervised 9 theses and 18 Master dissertations and mentored more than 50 engineer graduated projects in the industry. She is an associate editor of the International Journal of Advanced Robotic Systems (SAGE publishing), guest editor for the journals Complexity and Mathematical Problems in Engineering (Hindawi Publishing) and regional editor of the book series Emerging Methodologies and Applications in Modelling, Identification and Control (Elsevier Publishing). She also serves as scientific committee member in several international and peer-reviewed conferences. Professor Boubaker is the principal author of 7 books, editor of 6 special issues, and the author/co-author of more than 150 peer-reviewed papers. Quanmin Zhu Department of Engineering Design and Mathematics, University of the West of England, Bristol, UK. Quanmin Zhu is Professor of control systems at the Department of Engineering Design and Mathematics, University of the West of England, Bristol, UK. He obtained his MSc in Harbin Institute of Technology, China in 1983 and Ph.D. in Faculty of Engineering, University of Warwick, UK in 1989. His main research interest is in the area of nonlinear system modelling, identification, and control. His other research interest is in investigating electrodynamics of acupuncture points and sensory stimulation effects in human body, modelling of human meridian systems, and building up electro-acupuncture instruments. He has published over 200 papers on these topics, edited five Springer books and one book for the other publisher, and provided consultancy to various industries. Currently, Professor Zhu is acting as Editor of International Journal of Modelling, Identification and Control, Editor of International Journal of Computer Applications in Technology, Member of Editorial Committee of Chinese Journal of Scientific Instrument, and editor of Elsevier book series of Emerging Methodologies and Applications in Modelling, Identification and Control. He is the founder and president of series annual International Conference on Modelling, Identification and Control. Magdi S. Mahmoud King Fahd University of Petroleum and Minerals, Dhahran, Saudi Arabia. MagdiSadek Mahmoud obtained B. Sc. (Honors) in communication engineering, M. Sc. in electronic engineering and Ph. D. in systems engineering, all from Cairo University in 1968, 1972 and 1974, respectively. He has been a professor of engineering since 1984. He is now a Distinguished Professor at KFUPM, Saudi Arabia. He was on the faculty at different universities worldwide including Egypt (CU, AUC), Kuwait (KU), UAE (UAEU), UK (UMIST), USA (Pitt, Case Western), Singapore (Nanyang) and Australia (Adelaide). He lectured in Venezuela (Caracas), Germany (Hanover), UK ((Kent), USA (UoSA), Canada (Montreal) and China (BIT, Yanshan). He is the principal author of forty-six (46) books, inclusive book-chapters and the author/co-author of more than 580 peer-reviewed papers.
He is currently actively engaged in teaching and research in the development of modern methodologies to distributed control and filtering, networked-control systems, triggering mechanisms in dynamical systems, renewable-energy systems, and information technology. He is a fellow of the IEE, a senior member of the IEEE, a member of Sigma Xi, the CEI (UK), the Egyptian Engineers society, the Kuwait Engineers society and a registered consultant engineer of information engineering and systems (Egypt). Jose Ragot Centre de Recherche en Automatique de Nancy, Universit� de Lorraine, Vandoeuvre-l�s-Nancy C�dex, France. Jos� RAGOT received the "Diplome d'Ing�nieur" (Engineer Degree) with specialization in control from the Ecole Centrale de Nantes (France) in 1969. Then, he joined the University of Nancy (France) where is received the "Dipl�me d'Etudes Approfondies" (Master Degree) in 1970. In 1973 he obtained the "Dipl�me de Doctorat" (Ph. D. degree), a position as assistant professor at University Henri Poincar� in Nancy, and in 1980 the "Dipl�me de Doctorat-es-Sciences". Jos� Ragot moved up to professor in 1985 at the Institut National Polytechnique de Lorraine (INPL, National Polytechnic Institute of Lorraine).
His major research fields include data validation and reconciliation, process diagnosis, fault detection, and isolation. Another part of his activities is devoted to modelisation and state estimation adapted to process diagnosis and mainly in the field of multi-models.
Prof. Ragot is a researcher in the "Centre de Recherche en Automatique de Nancy" (CRAN, CNRS UMR 7039) where he was the head of the group "process diagnosis" during 12 years. Presently he is an Emeritus Professor (with the degree "Classe Exceptionnelle") at the "Ecole Nationale Sup�rieure de G�ologie" (french "Grande Ecole") where he has been in charge the formation in automatic control. Hamid Reza Karimi Professor of Applied Mechanics, Department of Mechanical Engineering, Politecnico di Milano, Milan, Italy. Dr. Karimi received the B.Sc. (First Hons.) degree in power systems from the Sharif University of Technology, Tehran, Iran, in 1998, and the M.Sc. and Ph.D. (First Hons.) degrees in control systems engineering from the University of Tehran, Tehran, in 2001 and 2005, respectively. His research interests are in the areas of control systems/theory, mechatronics, networked control systems, intelligent control systems, signal processing, vibration control, ground vehicles, structural control, wind turbine control and cutting processes. He is an Editorial Board Member for some international journals and several Technical Committee. Prof. Karimi has been presented a number of national and international awards, including Alexander-von-Humboldt Research Fellowship Award (in Germany), JSPS Research Award (in Japan), DAAD Research Award (in Germany), August-Wilhelm-Scheer Award (in Germany) and been invited as visiting professor at a number of universities in Germany, France, Italy, Poland, Spain, China, Korea, Japan, India. Jorge D�vila Instituto Polit�cnico Nacional (IPN), Mexico DF, Mexico. Jorge D�vila received the Ph.D. degree (2008) in Electrical Engineering from the National Autonomous University of Mexico (UNAM). He was awarded the Alfonso Caso Medal to the best Ph.D. student of the National Autonomous University of Mexico, UNAM, in 2010.
Prof. D�vila is a member of the Mexican National Research System, since January 2010, and he was awarded the distinction of National Researcher Level 2. He has published 27 journal articles, coauthored five book chapters and contributed with 68 conference papers. His works in observation, identification, and control of linear and nonlinear systems have been cited more than 1400 times (source: SCOPUS), he possesses h-index=16. Prof. D�vila was guest editor of the Special Issue: "Variable Structure Methods for Hybrid Systems,� International Journal of Systems Science, Volume 42, Issue 11, 2011. And currently is associate Editor of the Conference Editorial Board of IEEE Control Systems Society (since 2016).