ESD for R&D and Test

  • ID: 3942370
  • Training
  • Automated Learning Corporation
1 of 2
This comprehensive learning program addresses the needs of engineers and technicians in qualitatively and quantitatively understanding current ESD threats to electronic components and assemblies. Ted Dangelmayer demonstrates the breakthrough visualization of ESD events at they happen in real time. See the events, believe the results, and move to control these potentially destructive phenomena in your workplace!

Objectives

Participants successfully completing the program will be able to:

- Describe what static electricity is, how it is produced, and how its uncontrolled discharge can damage components and equipment
- Explain the Human Body Model (HMB) of ESD damage
- Identify correct procedures for controlling ESD caused by the HBM
- Describe the wrist strap as a critical component in HBM ESD control
- Describe how, where and when a wrist should be tested
- Explain the Charged Device Model (CDM) of ESD damage
- Identify correct procedures for controlling ESD caused by the Charged Device Model
- Describe safe and unsafe practice in handling assemblies

Qualification and Certification Testing

LearnTech® training incorporates interactive learning checks throughout the instructional sequences. Certification tests are criterion-referenced and module-based with feedback on every response for enhanced learning. Administrative access to dates and scores of tests, certifications, and re-certifications is compliant with ISO quality-standards requirements.

Standards Compliant:

ESD for R&D and Test complies with the ANSI/ESD S20.20 ESD control program guidelines as well as to JEDEC JESD625, IEC 61340-5, and IPC-610 standards.

Using the Course

- This course is designed to allow participants to learn at a convenient time, and at their own pace. You are free to pursue the course when and where you wish. You will require a broadband Internet connection, and a standard Internet browser with flash plugin.

- The course modules are listed in the most logical order for you to follow. However you can take the course modules in any order you wish.

- You are licensed to use this course for one year. This means that even after you have completed the course it is still available for review purposes. In review mode you can arrow forward and back through the course material to quickly locate specific content for reference, review, or further study.

- Course qualification testing is available. In addition, you can re-take any test if you are not satisfied with your initial result.

We recommend:

- Take the course and complete all modules.
- Take the course test.
- Make notes while taking the test to highlight content that proves difficult.
- Review the course with additional study of this difficult content.
- Retake the test to demonstrate your mastery of the content.

Following this process helps you to achieve greater learning and a more accurate test assessment.

Course Times

The time to complete the course will vary depending on prior knowledge, learning style, and individual differences. The more study and review, the greater the knowledge and understanding, and the higher your mastery test scores. Plan your time accordingly.
READ MORE
Note: Product cover images may vary from those shown
2 of 2
Modules:

1. Introduction
2. ESD: Human Body Model
3. HBM Control Procedures
4. ESD: Charged Device Model
5. CDM Control Procedures

This course will take approximately 1 hour to complete.
Note: Product cover images may vary from those shown
3 of 2

Loading
LOADING...

4 of 2
Note: Product cover images may vary from those shown
Adroll
adroll