+353-1-416-8900REST OF WORLD
+44-20-3973-8888REST OF WORLD
1-917-300-0470EAST COAST U.S
1-800-526-8630U.S. (TOLL FREE)
New

Asia-Pacific Data Center Sustainable Cooling - Market Share Analysis, Industry Trends & Statistics, Growth Forecasts (2027-2032)

  • PDF Icon

    Report

  • 167 Pages
  • November 2026
  • Region: Asia Pacific
  • Mordor Intelligence
  • ID: 6294629
The Asia-Pacific data center sustainable cooling market size was valued at USD 4.68 billion in 2026 and is estimated to grow from USD 5.34 billion in 2027 to reach USD 10.03 billion by 2032, at a CAGR of 13.44% during the forecast period (2027-2032). This report is Segmented by Cooling Technology (Air-Based, Immersion, and More), Heat Rejection Technology (Air-Cooled, and More), Cooling System Component (CDUs, Chillers, and More), Sustainability Approach (Energy-Efficient, and More), Data Center Size (Small, and More), Data Center Type (CSPs, and More), and Geography. The Market Forecasts are Provided in Terms of Value (USD).

Asia-Pacific Data Center Sustainable Cooling Market Trends and Insights

AI and High-Performance Computing Rack Power Densification

Artificial intelligence inference workloads generally require 20-40 kW per rack, while training configurations can exceed 100 kW per rack. Older halls designed for loads below 30 kW per rack need substantial cooling changes before they can host dense AI systems. Princeton Digital Group’s TY1 campus in Greater Tokyo supports densities above 140 kW per rack and received NVIDIA DGX-Ready Data Center certification for liquid cooling. AI clusters also tend to operate near their thermal peak for extended periods, leaving less of the part-load relief that legacy cooling systems relied on. ST Telemedia Global Data Centres stated that its Bangkok direct-to-chip deployment supports at least 150 kW per rack and can reduce cooling energy use by 20-30% against air-cooled configurations. This requirement favors CDUs, cold plates, leak detection, and controls that can manage stable, high-density thermal conditions.

Hyperscale, Cloud, and Colocation Capacity Expansion

The Asia-Pacific data center sustainable cooling market is supported by the expanding construction pipeline for cloud, colocation, and hyperscale capacity. Facilities designed for AI workloads need equipment sized for much higher rack density than previous builds. This moves cooling decisions earlier in project design and increases the value of vendors that can coordinate facility and rack-level systems. Liquid-cooling-ready colocation can also offer a differentiated service to tenants that cannot operate their own thermal systems. That service model creates demand for CDUs, coolant distribution, monitoring, and field support rather than only standalone equipment. The result is a broader revenue opportunity across equipment, integration, and lifecycle services.

High Upfront Cost and Retrofit Complexity

Full direct-to-chip conversion at an existing site entails high per-MW costs for IT load, while greenfield liquid-cooling builds require even higher per-MW investment. Legacy facilities often need piping, manifolds, CDUs, leak detection, and commissioning in addition to cooling hardware. Raised-floor congestion, ceiling restrictions, and structural loading constraints can make conversion difficult. Operators must also maintain uptime commitments while upgrades are underway. This usually requires phased work rather than a single facility-wide conversion. The cost and disruption keep adoption most accessible to large and hyperscale operators with stronger capital capacity.

Other drivers and restraints analyzed in the detailed report include:

  1. PUE, WUE, and Low-Carbon Data Center Requirements
  2. Growth of Edge Computing and 5G-Enabled Distributed Infrastructure
  3. Shortage of HVAC, Liquid-Cooling, and Commissioning Skills

Segment Analysis

Air-based cooling held 45.94% of the Asia-Pacific data center sustainable cooling market share in 2026, supported by the large installed base of CRAC and CRAH equipment in enterprise and mid-tier colocation facilities. Its position reflects existing infrastructure and lower entry costs for medium-density applications. The segment is likely to lose relative weight as new AI-focused campuses adopt liquid cooling at the design stage. Direct-to-chip liquid cooling is projected to expand at a 13.57% CAGR through 2032. It is being adopted for GPU clusters with rack loads of 70 kW and above. The technology supports a direct path for removing heat from high-density processors. It also requires a more integrated approach to distribution, controls, and service.

Immersion cooling has a smaller revenue base, but it is moving toward broader commercial use. Castrol’s regional industry discussion identified fluid leakage, implementation time, and maintenance as important barriers for single-phase immersion systems. Rear-door heat exchangers can provide a practical intermediate option for sites managing 30-50 kW racks. They work with existing air-side designs while increasing the thermal capacity available near the rack. Evaporative, adiabatic, and free-cooling systems also remain relevant in markets with favorable ambient conditions. Australia and Japan can use more free-cooling hours in suitable locations, which can reduce mechanical refrigeration demand. These technologies will continue to coexist because site climate, water availability, building layout, and rack density differ across the region.

Air-cooled systems accounted for 32.27% of the Asia-Pacific data center sustainable cooling market in 2026. Their installed position reflects compatibility with established air-side infrastructure and lower direct water use. Hybrid heat rejection systems are projected to expand at a 13.68% CAGR through 2032. These systems combine dry cooling, adiabatic operation, and chilled-water circuits. The combination lets operators adjust operating modes according to ambient conditions and workload. It also helps sites manage the PUE and WUE trade-off under changing weather and resource conditions. This flexibility is especially important in tropical locations where both power use and water use are closely monitored.

Closed-loop and hybrid designs can reduce freshwater intake by 50-70% compared with conventional evaporative systems. Water-cooled and evaporative designs remain useful where warm-water loops and climate conditions support efficient operation. Dry coolers are gaining relevance in locations facing tighter water constraints. The mix of liquid cooling for dense AI racks and ambient air cooling for lower-density equipment supports the use of multiple heat rejection methods at the same facility. This reduces the likelihood that a single technology will meet every use case. The Asia-Pacific data center sustainable cooling industry will therefore need designs that can be configured around local water conditions, climate, and workload mix.

Complete Report Scope:

  • By Cooling Technology
    • Air-Based Cooling
    • Direct-to-Chip Liquid Cooling
    • Immersion Cooling
    • Rear-Door Heat Exchangers
    • Evaporative and Adiabatic Cooling
    • Free Cooling and Economizer Systems
    • Other Sustainable Cooling Technologies
  • By Heat Rejection Technology
    • Air-Cooled Systems
    • Water-Cooled Systems
    • Evaporative Heat Rejection
    • Dry Coolers
    • Hybrid Heat Rejection Systems
  • By Cooling System Component
    • Cooling Distribution Units (CDUs)
    • Chillers
    • Cooling Towers
    • Heat Exchangers
    • Pumps and Fluid Distribution Systems
    • Fans and Air Handling Equipment
    • Cooling Controls and Monitoring Systems
  • By Sustainability Approach
    • Energy-Efficient Cooling
    • Water-Efficient Cooling
    • Low-Global-Warming-Potential Refrigerant Solutions
    • Heat Recovery-Enabled Cooling
    • Integrated Cooling Optimization and Controls
  • By Data Center Size
    • Small
    • Medium
    • Large
    • Hyperscale
  • By Data Center Type
    • Colocation
    • Cloud Service Providers (CSPs)
    • Enterprise and Edge
  • By Geography
    • China
    • India
    • Japan
    • Australia
    • Singapore
    • South Korea
    • Malaysia
    • Indonesia
    • Rest of Asia-Pacific

List of Companies Covered in this Report:

  1. Schneider Electric SE
  2. Vertiv Group Corp.
  3. Johnson Controls International plc
  4. STULZ GmbH
  5. Rittal GmbH & Co. KG
  6. Mitsubishi Electric Corporation
  7. Huawei Digital Power Technologies Co., Ltd.
  8. Daikin Industries, Ltd.
  9. Delta Electronics, Inc.
  10. Munters AB
  11. Trane Technologies plc
  12. CoolIT Systems, Inc.
  13. Submer Technologies, S.L.
  14. Iceotope Technologies Ltd.
  15. Green Revolution Cooling, Inc.
  16. Alfa Laval AB
  17. Grundfos Holding A/S
  18. Xylem Inc.
  19. NTT Facilities, Inc.
  20. Fujitsu Limited

Additional Benefits:

  • The market estimate (ME) sheet in Excel format
  • 3 months of analyst support

Table of Contents

1 INTRODUCTION
1.1 Study Assumptions and Market Definition
1.2 Scope of the Study
2 RESEARCH METHODOLOGY3 EXECUTIVE SUMMARY
4 MARKET LANDSCAPE
4.1 Market Overview
4.2 Market Drivers
4.2.1 AI and High-Performance Computing Rack Power Densification
4.2.2 Hyperscale, Cloud, and Colocation Capacity Expansion
4.2.3 PUE, WUE, and Low-Carbon Data Center Requirements
4.2.4 Growth of Edge Computing and 5G-Enabled Distributed Infrastructure
4.2.5 Water-Stress-Driven Shift to Closed-Loop and Low-Water Cooling
4.2.6 Liquid-Cooling-Ready Local Manufacturing and Supply Ecosystems
4.3 Market Restraints
4.3.1 High Upfront Cost and Retrofit Complexity
4.3.2 Shortage of HVAC, Liquid-Cooling, and Commissioning Skills
4.3.3 Fluid Compatibility, Warranty, and Certification Uncertainty
4.3.4 Water, Power, and Environmental Approval Constraints in High-Growth Hubs
4.4 Impact of Macroeconomic Factors on the Market
4.5 Industry Value Chain Analysis
4.6 Regulatory Landscape
4.7 Technological Outlook
4.8 Porter's Five Forces Analysis
4.8.1 Competitive Rivalry
4.8.2 Threat of New Entrants
4.8.3 Bargaining Power of Suppliers
4.8.4 Bargaining Power of Buyers
4.8.5 Threat of Substitutes
5 MARKET SIZE AND GROWTH FORECASTS (VALUE)
5.1 By Cooling Technology
5.1.1 Air-Based Cooling
5.1.2 Direct-to-Chip Liquid Cooling
5.1.3 Immersion Cooling
5.1.4 Rear-Door Heat Exchangers
5.1.5 Evaporative and Adiabatic Cooling
5.1.6 Free Cooling and Economizer Systems
5.1.7 Other Sustainable Cooling Technologies
5.2 By Heat Rejection Technology
5.2.1 Air-Cooled Systems
5.2.2 Water-Cooled Systems
5.2.3 Evaporative Heat Rejection
5.2.4 Dry Coolers
5.2.5 Hybrid Heat Rejection Systems
5.3 By Cooling System Component
5.3.1 Cooling Distribution Units (CDUs)
5.3.2 Chillers
5.3.3 Cooling Towers
5.3.4 Heat Exchangers
5.3.5 Pumps and Fluid Distribution Systems
5.3.6 Fans and Air Handling Equipment
5.3.7 Cooling Controls and Monitoring Systems
5.4 By Sustainability Approach
5.4.1 Energy-Efficient Cooling
5.4.2 Water-Efficient Cooling
5.4.3 Low-Global-Warming-Potential Refrigerant Solutions
5.4.4 Heat Recovery-Enabled Cooling
5.4.5 Integrated Cooling Optimization and Controls
5.5 By Data Center Size
5.5.1 Small
5.5.2 Medium
5.5.3 Large
5.5.4 Hyperscale
5.6 By Data Center Type
5.6.1 Colocation
5.6.2 Cloud Service Providers (CSPs)
5.6.3 Enterprise and Edge
5.7 By Geography
5.7.1 China
5.7.2 India
5.7.3 Japan
5.7.4 Australia
5.7.5 Singapore
5.7.6 South Korea
5.7.7 Malaysia
5.7.8 Indonesia
5.7.9 Rest of Asia-Pacific
6 COMPETITIVE LANDSCAPE
6.1 Market Concentration
6.2 Strategic Moves
6.3 Market Share Analysis
6.4 Company Profiles (includes Global Level Overview, Market Level Overview, Core Segments, Financials as available, Strategic Information, Market Rank/Share, Products and Services, Recent Developments)
6.4.1 Schneider Electric SE
6.4.2 Vertiv Group Corp.
6.4.3 Johnson Controls International plc
6.4.4 STULZ GmbH
6.4.5 Rittal GmbH & Co. KG
6.4.6 Mitsubishi Electric Corporation
6.4.7 Huawei Digital Power Technologies Co., Ltd.
6.4.8 Daikin Industries, Ltd.
6.4.9 Delta Electronics, Inc.
6.4.10 Munters AB
6.4.11 Trane Technologies plc
6.4.12 CoolIT Systems, Inc.
6.4.13 Submer Technologies, S.L.
6.4.14 Iceotope Technologies Ltd.
6.4.15 Green Revolution Cooling, Inc.
6.4.16 Alfa Laval AB
6.4.17 Grundfos Holding A/S
6.4.18 Xylem Inc.
6.4.19 NTT Facilities, Inc.
6.4.20 Fujitsu Limited
7 MARKET OPPORTUNITIES AND FUTURE OUTLOOK
7.1 White-Space and Unmet-Need Assessment

Companies Mentioned (Partial List)

A selection of companies mentioned in this report includes, but is not limited to:

  • Schneider Electric SE
  • Vertiv Group Corp.
  • Johnson Controls International plc
  • STULZ GmbH
  • Rittal GmbH & Co. KG
  • Mitsubishi Electric Corporation
  • Huawei Digital Power Technologies Co., Ltd.
  • Daikin Industries, Ltd.
  • Delta Electronics, Inc.
  • Munters AB
  • Trane Technologies plc
  • CoolIT Systems, Inc.
  • Submer Technologies, S.L.
  • Iceotope Technologies Ltd.
  • Green Revolution Cooling, Inc.
  • Alfa Laval AB
  • Grundfos Holding A/S
  • Xylem Inc.
  • NTT Facilities, Inc.
  • Fujitsu Limited